top of page

Gilles - Foam Latex

 

Mould materials:
-Epoxy moulds

-Soft silicone moulds will damage very quickly 

-Plaster moulds, ultra cal - you have to wait for it to cool

-Fibreglass moulds - don't have to wait for it to cool

 

 

Release Agents:

-3M Display mount- helps foam grab onto detail
-Monster makers mould release (metallic)


-Use 3M if you use silicone or fibreglass- any non porous material 
-Porous surfaces use monster release (metallic one) 

 

Adhesives:


If you bake longer and lower heat you have ability to stretch it when you apply it 

Use snappy g or prosaide to adhere foam latex pieces on 

Prosaide cream thicker can help with edges 

 

 

Sealing:

To seal the foam in preparation for painting, use prosaide, do this onto the skin too to give the same texture to work on.

 

Painting:

-Can use any acrylics on foam 
Food colourings for a base as it will be opaque 

-Build up layers of washes with colours

Prosaide and acrylic paint makes pax paint Can use skin illustrator 

 

-If you pre paint leave 5mm non painted so it's easier to match skin

 

-Mask grease doesn't set, it stays greasy, but can be used in sensitive areas such as the eyes, Almond oil is useful around the eyes when colouring



Foam flat pieces:

Could use:  Plaster mould, but could be brittle
                   Fibreglass 
                   Plastil (can be baked) 


Finish:
Gloss- graphic gel to make glossy and wet, 5 minute epoxy - 2 part glue, looks like eyes
glycerine is a non permanent method 
Permawet- wet look but dry to touch 

 

Tips:

-For fibreglass moulds you have to bake it first to get the chemicals out to stop the appliance coming out green.

Foam Latex: Q&A

© 2016 by Bethany Lane Proudly created with Wix.com

  • Facebook Black Round
  • Instagram Black Round
  • Twitter Black Round
  • Vimeo Black Round
bottom of page